Search
Directory
Brands
American Dynamics manuals
Cameras
Tyco 8
Manual
American Dynamics Tyco 8 User Manual
Installation guide
Text mode
Original mode
Part Number 8200-0885-01 A0
Installation Guide
IP SpeedDome Ultra 8
Version 1.0
Pages:
1
2
3
4
5
6
7
…
42
wrong Brand
wrong Model
non readable
Table of contents
Document Outline
1 About this guide
The SpeedDome Ultra 8 can be installed using the following mounts
General Requirements
Save Packaging Material
2 Introduction
Installation
Installation process
3 Installing IP SDU8 with an Indoor Hardmount
Preparing and installing the Indoor Hardmount Housing
4 Installing IP SpeedDome Ultra 8 with a RHOPN Pendant Mounting
Assembly of the RHOPN Pendant Mount
Preparing the Pendant Housing
Attaching the Bubble to the IP SpeedDome Ultra 8 Unit
5 Installing IP SDU8 with a ROENDC End Cap
Preparing and installing the SDU8 Camera in an End Cap Assembly
Preparing and installing the SDU8 Camera in an End Cap Assembly
Attaching the Bubble to the IP SDU8 Unit
6 Restoring factory defaults
Resetting the IPSDU8
Restoring factory defaults on the IPSDU8
7 Technical Specifications
Diagnostic LEDs
Diagnostic LED Status Descriptions
Pin Outs for the IP SpeedDome Ultra 8
3 wire 24VAC supply
RJ-45 Ethernet interface (with female to female adaptor)
Alarm connector pin-out for Indoor I/O base
Alarm connector pin-out for Outdoor I/O base
See also other documents in the category American Dynamics Cameras:
ADCA470CAFN
(2 pages)
ADC733
(2 pages)
Tyco ADC770
(2 pages)
ADCA Series
(1 page)
Tyco VII
(4 pages)
