American Dynamics Tyco 8 - Manual (Page 10)

Introduction
2-2 Installation Guide
Installation process
Figure 2-2 Installation process flowchart
Referring to the IPSDU8 Installation Guide (8200-0885-01) install
the following:
• Mount (which has PCB and cables installed)
• SDU8
• Bubble
Remove the IPSDU8, dome camera and corresponding mount from
Refer to the Intellex/VideoEdge™ NVR Setup Guide and follow the
procedure for adding a IPSDU8.
Refer to Web Configuration (Chapter 3) and configure the following
• TCP/IP settings
• Video Input (if applicable)
• Event Inputs (if applicable)
their packaging.
Ensure the required power, network and alarm cables are
installed and the network cable is labelled and disconnected at
the network patch panel or access point.
settings on the IPSDU8:
Within the browser window navigate to the Live video page and follow
the Web Configuration chapter to access the SDU8 dome configuration
menu, then using the SDU8 User Manuals, configure the required
dome settings.
Connect a laptop to the
NO YES
IPSDU8 Ethernet cable
located at the patch
panel or access point.
Connect the IPSDU8
Ethernet cable into
the network patch
panel or access point.
Open a browser window and enter the IP address of the IPSDU8,
192.168.1.80.
as the Intellex or
Is the IPSDU8 on the
same subnet address
VideoEdge™ NVR?
If a laptop was used to configure the IPSDU8, disconnect the laptop
and connect the IPSDU8 Ethernet cable into the network patch panel
or access point.