Ramsey Winch HD-234 - Manual (Page 9)

9
CONDITION POSSIBLE CAUSE CORRECTION
1. Dry or rusted shaft. 1. Clean and lubricate
2. Bent yoke or linkage. 2. Replace yoke or shaft assembly.
3. Clutch jaws are in contact. 3. See Techniques of Operation .
1. Seal damaged or worn. 1. Replace seal.
2. Too much oil.
2. Drain excess oil. Refer to
Techniques of Operation .
3. Damaged gasket. 3. Replace gasket.
1. Hydraulic motor worn out. 1. Replace motor.
2. Low flow rate.
2. Check flow rate. Refer to
Hydraulic Systems flow chart.
CABLE BIRDNESTS WHEN
CLUTCH IS DISENGAGED
1. Drag brake disc worn. 1. Replace discs.
HYDRAULIC FLUID LEAKS
OUT HOLE IN MOTOR
ADAPTER
1. Hydraulic motor shaft seal
damaged.
1. Replace seal.
CLUTCH INOPERATIVE OR
BINDS UP
OIL LEAKS FROM
HOUSING
WINCH RUNS TOO SLOW
Troubleshooting Guide