Ramsey Winch HD-234 - Manual (Page 12)

6. Remove gear housing cover (item #6)
from gear housing (item #11) by
unscrewing capscrews (item #18).
Thread two of the capscrews into the
two tapped holes of cover and tighten.
This will pull the cover loose from the
gear housing.
Remove cover gasket (item #31) and
pull shaft (item #13), with gear
attached, and thrust washer (item #42)
from gear housing.
7. Check for signs of wear on gear teeth. If
replacement of gear is necessary, replace as
follows:
a) Press gear (item #8) from shaft (item #13).
b) Examine shaft keys and keyways. If distor-
tion of keys and/or keyways is evident, shaft
and keys should be replaced.
c) Use a soft hammer to gently tap keys (item
#33) into keyways. Press gear (item #8)
over shaft and keys. Gear must be centered over keys.
8. Remove seal (item #43) from back of
gear housing (item #11). Press bush-
ing (item #17) from gear housing.
Press new bushing and seal back into
place.
9. Check drum bushings (item #16) for
signs of wear. Replace if necessary
by pressing old bushings from drum.
Press new ones into place.
12
18
6
8
11
13
42
31
33
13
8
33
43
11
17
16
7
16