Ramsey Winch HD-234 User Manual

Page 16

17.Place thrust washer (item #47) over

end of drum shaft and slide downward
until space rests on drum. Press drum
downward to compress springs in gear
housing.

Insert keys (item #32) into keyways
with sharp edge of keys pointing out-
ward and notched end of keys upward.
A rubber or brass mallet will be needed
to gently tap keys into position.

Apply grease to keys and end of shaft.
Place jaw clutch (item #5) over end of
shaft and slide jaw clutch over keys.

Set clutch housing (item #10) over end
of drum shaft. Pull jaw clutch (item #5)
upward, toward clutch housing, enough to allow yoke, in clutch housing,
to fit properly in groove around jaw clutch.

18.Attach two mounting angles (item #2) using six capscrews (item #21)

with lockwashers and two capscrews (item #20). Tighten capscrews to
34 ft-lbs. (46 Nm) each. Insert plug (item #38) into bottom of gear
housing. Permatex may be applied to threads to help prevent leakage.

Pour 3/4 pint of Phillips SMP 80W-90, Mobil HD 80W-90, Shell
Spirax HD 80W-90, or CITGO MP 80W-90 gear oil only into housing
through hole in top of
housing. Insert relief
fitting (item #35)
into reducer (item
#37). Reducer
should then be
placed into hole on
top of gear housing.
tighten fitting and
reducer securely.