Ramsey Winch HD-234 - Manual (Page 15)

15.Press bearing (item #15) onto
worm and into housing. Note: Be
sure that thick shoulder of bear-
ing’s outer race (side with manu-
facturer’s name and part number)
is out, away from worm threads.
Place gasket (item #30) onto
adapter (item #2). Attach adapter
to gear housing using four cap-
screws (item #22). Tighten cap-
screws to 12 ft-lbs. (16.3 Nm)
each. Insert key (item #12) into
keyway of worm shaft. Slide
tapered end of coupling (item #28)
over end of worm shaft. Be sure
roll pin (item #39) is in coupling.
Place motor shaft, with key in keyway, into coupling. Secure motor (item
#36) to adapter, using two capscrews (item #23) and lockwashers.
Tighten capscrews to 75 ft-lbs. (102 Nm) each.
16.Place winch with gear housing cover
down on work bench. Drum shaft should
be in vertical position. Slide thrust wash-
er (item #46) over drum shaft and slide
downward until washer rests on gear
housing. Set springs (item #44) into
pockets of gear housing with drag
brakes (item #29) on top of springs.
Slide drum assembly (item #7) onto
drum shaft with drum jaws upward.
15
42
15
28
30
12
2
23
36
22
27
39
46
7
44
29