Ramsey Winch HD-234 - Manual (Page 11)

3. Remove key (item #12) from worm
shaft.
Remove bearing cap (item #4) and
gasket (item #30) by unscrewing four
capscrews (item #18)
Remove seal (item #42) from bearing
cap and press new seal into place.
Drag brake disc (item #29) and spring
should be examined and replaced if
necessary.
4. Remove motor (item #36) and coupling
(item #28) from adapter (item #2) by
unscrewing two capscrews (item #23).
Remove key (item #12) from worm
shaft. Unscrew four capscrews (item
#22) and remove adapter from gear
housing. Replace adapter seal (item
#42) and gasket (item #30).
5. Remove bearing cap (item #4) from
gear housing by unscrewing four cap-
screws (item #18). Remove worm
(item #14) and bearings (item #15)
from gear housing. Use soft hammer to
gently tap input end of worm and drive
worm and bearing from gear housing.
Once worm has been removed from
housing, bearing can be pressed from
end of worm.
Check for signs of wear or damage to worm (item #14) and bearing (item #15).
Replace if necessary.
11
12
18
4
30
29
29
44
44
42
2
36
23 27
23
39
42
28
12
30
15
15
30
14
18
4