Ramsey Winch ATV UNIVERSAL WIRELESS REMOTE FOR ATV WINCHES User Manual

Page 6

NOTE: For clarification see wiring schematic on page 5.

1. Connect red wire to center spade.

2. Connect green wire to the toggle switch terminal in the “OUT” position.

3. Connect the yellow wire to the toggle switch terminal in the “IN” position.

1. Locate accessory wire from ATV ignition.

NOTE: Accessory wire should have 12 volts only when ignition
key is on.

2. Cut spade connector off and connect red wire from receiver to accesso-

ry wire using supplied quick splice connector.

Wiring the Toggle Switch

Connecting the Power Lead

Installing the Antenna

NOTE: For clarification see wiring schematic on page 5.

1. Clean predetermined mounting surface with Isopropyl alcohol and buff

dry. (In ATVs without hoods the best place to mount the antenna will be
the underside of the ATV cowling in the highest possible position.)

2. Remove backing from top side of double-stick tape and apply to back

side of pc board. Remove backing from other side of double-stick tape
and position pc board in center at the predetermined mounting location
on inside surface of cowling or hood.

3. Remove backing from copper tape. Carefully affix tape to terminal on

right side of pc board and follow contour of inside of cowling. DO NOT
ALTER LENGTH OF THE TAPE. Repeat for left side.

4. Route coax cable up from receiver to antenna and plug in at pc board.

251203 SUPERWINCH ATV 2000 & T 1500