Ramsey Winch ATV UNIVERSAL WIRELESS REMOTE FOR ATV WINCHES - Manual (Page 11)

9
NOTE: For clarification see wiring schematic on page 11.
1. Attach black with yellow stripe motor lead to lower right terminal
stud “B” on solenoid.
2. Attach black motor lead to lower left terminal stud “C” on solenoid.
3. Attach connector with 2 yellow wires to the terminal directly above
the black with yellow stripe motor lead.
4. Attach connector with 2 green wires to the terminal directly above
the black motor lead.
5. Attach black battery lead to upper left terminal stud “E” on solenoid.
6. Attach red battery lead to upper right terminal stud “A” on solenoid.
Connecting Wiring to Solenoids
Installing the Solenoid
1. Mount solenoid in location determined previously.
2. Secure using (1) tube clamp, (1) #10-24 screw, (1) flat washer,
and (1) lock nut each side of solenoid assembly.
CAUTION: Be sure that no wire connections are in contact
with either the ATV frame or with each other as a direct short
will occur.
Installing the Toggle Switch
1. Route red, yellow and green wires to toggle switch location .
2. Drill 1/2” hole in location for toggle switch installation.
3. Insert switch through hole in drilled in previous step.
4. Place directional plate over switch and secure using hex nut. Make
sure directional plate is installed in the same direction as the tog-
gle switch movement.
5. Place rubber boot over switch and tighten securely.
251204 WARN A2000 / SUPERWINCH X1, X2, X1F, X2F, EX1