Ramsey Winch ATV UNIVERSAL WIRELESS REMOTE FOR ATV WINCHES - Manual (Page 10)

Installing the Receiver
1. Insert plastic tie through mounting ears on receiver and secure
receiver to location determined above.
2. Tighten plastic tie and clip excess.
3. Attach ground wire to ATV frame.
Caution: Do not alter the length of the ground wire as
this will affect performance of the remote.
4. Attach wiring harness to receiver & route yellow and green wires
to solenoid location.
Installing the Motor Leads
1. Remove existing manual switch, motor leads, and battery leads
from winch.
2. If you have a WARN A2000:
a. Connect black wire to #2 stud on motor.
b. Connect black with yellow stripe wire to #1 stud.
c. Route wires to solenoid location.
3. If you have a SUPERWINCH X1, X2, X1F, X2F, OR EX1:
a. Connect black wire to stud closest to front of winch.
b. Connect black with yellow stripe wire to rear stud.
c. Route wires to solenoid location.
8
251204 WARN A2000 / SUPERWINCH X1, X2, X1F, X2F, EX1
Before Beginning Installation
1. Disconnect power lead from winch to battery.
2. Disengage winch clutch.
3. Remove hood or cowling as necessary for easier access to instal-
lation area.
4. Locate & mark mounting locations for receiver, toggle switch, sole-
noid assembly, & antenna.
NOTE:
Make sure locations are close enough for wiring connections to be
made without making alterations to wire lengths. Solenoid assem-
bly will be mounted to tube frame of ATV using supplied tube
clamps, except Polaris models which mount directly to the ATV
cross member under hood using supplied mounting screws .
Antenna will need a space of at least 15” wide under cowling or
hood for mounting in the horizontal configuration required for best
reception. Antenna is flexible and will follow the contour of the
cowling or hood. The antenna should be mounted at least 10” from
winch motor and battery leads.