Ramsey Winch ATV UNIVERSAL WIRELESS REMOTE FOR ATV WINCHES - Manual (Page 4)

251203 SUPERWINCH ATV 2000 & T 1500
Before Beginning Installation
1. Disconnect power lead from winch to battery.
2. Disengage winch clutch.
3. Remove hood or cowling as necessary for easier access to installation area.
4. Locate & mark mounting locations for receiver, toggle switch, solenoid
assembly, & antenna.
NOTE:
Make sure locations are close enough for wiring connections to be
made without making alterations to wire lengths. Solenoid assembly
will be mounted to tube frame of ATV using supplied tube clamps,
except for Polaris models which mount directly to the ATV crossmem-
ber under hood, using supplied mounting screws.
Antenna will need a space of at least 15” wide under cowling or hood
for mounting in the horizontal configuration required for best recep-
tion. Antenna is flexible and will follow the contour of the cowling or
hood. The antenna should be mounted at least 10” from winch motor
and battery leads.
Installing the Receiver
1. Insert plastic tie through mounting ears on receiver and secure receiver to
location determined above.
2. Tighten plastic tie and clip excess.
3. Attach ground wire to ATV frame.
CAUTION: Do not alter the length of the ground wire as this will affect
performance of the remote.
4. Attach wiring harness to receiver & route yellow and green wires to solenoid
location.
Installing the Ring Terminals
1. Remove rocker switch assembly from handlebar.
2. Disconnect wires from rocker switch.
3. Cut spade terminals off ends of battery and motor leads.
4. Slip rubber boots over ends of wires and install supplied ring terminals in
place of spade connectors.
5. Route wires to location where solenoid will be mounted.
2