Ramsey Winch ATV UNIVERSAL WIRELESS REMOTE FOR ATV WINCHES - Manual (Page 17)

251205 WARN A2500
15
Installing the Antenna
NOTE: For clarification see wiring schematic below.
1. Clean predetermined mounting surface with Isopropyl alcohol and
buff dry. (In ATVs without hoods the best place to mount the
antenna will be the underside of the ATV cowling in the highest
possible position.)
2. Remove backing from top side of double-stick tape and apply to
back side of pc board. Remove backing from other side of double-
stick tape and position pc board in center on top inside surface of
cowling or hood at the predetermined mounting location.
3. Remove backing from copper tape. Carefully affix tape to terminal
on right side of pc board and follow contour of inside of cowling.
DO NOT ALTER LENGTH OF THE TAPE. Repeat for left side.
4. Route coax cable up from receiver to antenna and plug in at pc
board.
Programing instructions: Press and hold membrane below,
press ON/OFF button on transmitter for 3 seconds ,
press OUT button for 3 seconds or until winch activation .
WWW.RAMSEY.COM (918)438-2760 FAX(918)438-6688
Tulsa . Oklahoma, USA .
.
PUSH
BLACK WIRE
TO GROUND
TO REMOTE RECEPTACLE
REMOTE
ADAPTER CABLE
WIRELESS
SIGNAL
ANTENNA
RECEIVER
COAX CABLE
RIGHT CONTACT
LEFT CONTACT
COPPER TAPE
Electrical Schematic
ON
/O FF
IN
OU
T
TRANSMITTER