Ramsey Winch ATV UNIVERSAL WIRELESS REMOTE FOR ATV WINCHES User Manual

Page 20

251206 SUPERWINCH X1, X2, X1F, XF2 EX1 (W/ HAND HELD REMOTE)

Before Beginning Installation

1. Disconnect power lead from solenoid to battery.

2. Disengage winch clutch.

3. Remove hood or cowling as necessary for easier access to installa-

tion area.

4. Locate & mark mounting locations for receiver, & antenna.

NOTE:
Make sure locations are close enough for wiring connec-
tions to be made without making alterations to wire
lengths. Antenna will need a space of at least 15” wide
under cowling or hood for mounting in the horizontal con-
figuration required for best reception. Antenna is flexible
and will follow the contour of the cowling or hood. The
antenna should be mounted at least 10” from winch motor
and battery leads.

Installing the Receiver

1. Insert plastic tie through mounting ears on receiver and secure

receiver to location determined above.

2. Tighten plastic tie and clip excess.

3. Attach ground wire to ATV frame.

Caution: Do not alter the length of the ground wire as this
will affect performance of the remote.

1. Route adapter cable to receiver and plug in to receptacle.
2. Plug adapter cable into winch remote receptacle.
3 Find a suitable location for remote adapter cable storage clip.
4. Clean mounting surface with isopropyl alcohol and buff dry. Affix

storage clip.
NOTE: Discard remaining wiring harness.
WARNING: When winch is not in use, unplug adapter cable and
secure with adapter cable storage clip.

Installing the Adapter Cable