Ramsey Winch ATV UNIVERSAL WIRELESS REMOTE FOR ATV WINCHES - Manual (Page 5)

NOTE: For clarification see wiring schematic on page 5.
1. Attach black with yellow stripe motor lead to lower right terminal stud
“B” on solenoid.
2. Attach black motor lead to lower left terminal stud “C” on solenoid.
3. Attach connector with 2 yellow wires to the terminal directly above the
black with yellow stripe motor lead.
4. Attach connector with 2 green wires to the terminal directly above the
black motor lead.
5. Attach black battery lead to upper left terminal stud “E” on solenoid.
6. Attach red battery lead to upper right stud “A” on solenoid.
Connecting Wiring to Solenoids
Installing the Solenoid
1. Mount solenoid in location determined previously.
2. Secure using (1) tube clamp, (1) #10-24 screw, (1) flat washer, and (1)
lock nut each side of solenoid assembly.
CAUTION: Be sure that no wire connections are in contact with
either the ATV frame or with each other as a direct short will
occur.
Installing the Toggle Switch
1. Route red, yellow, and green wires to toggle switch location .
2. Drill 1/2” hole in location for toggle switch installation.
3. Insert switch through hole in drilled in previous step.
4. Place directional plate over switch and secure using hex nut. Make sure
directional plate is installed in the same direction as the toggle switch
operates.
5. Place rubber boot over switch and tighten securely.
251203 SUPERWINCH ATV 2000 & T 1500
3