Aiwa XP-R220 - Manual (Page 6)

B
display changes to .
Note
• You cannot back to previous track by pressing
r during random play.
• You cannot select one-track repeat during random play.
Repeat play
→
M
Press PLAY MODE during playback to select repeat play as follows.
: one-track repeat
V
: all-track repeat
V
no repeat play (normal play)
PROGRAM PLAY
→
N
Up to 24 tracks can be chosen for program play.
1 Press ENTER/DISP while in standby mode to display “P-01”.
2 Select the desired track by pressing
r and t .
a track number
b program number
3 Press ENTER/DISP within 8 seconds.
If it is not pressed within 8 seconds, the track number changes to 00. Repeat
the procedure from step 2 again.
4 Repeat steps 2 and 3 to program more tracks.
5 Press
e PLAY/PAUSE to start program play.
To stop program play
Press
s STOP/OFF/CHARGE.
To add tracks to the program
Repeat steps 2 and 3 before you proceed to step 5. You can add tracks to the
end of the program.
To erase the program
Press
s STOP/OFF/CHARGE while in standby mode.
To check the programmed tracks
Press ENTER/DISP repeatedly before you proceed to step 5.
The number of each programmed track will be displayed in order of playback.
Note
• The program is also erased when the disc compartment is opened or the auto
power off function turns the power off.
• When 24 tracks are programmed, “P-FULL” appears, and no more tracks may
be added.
• You cannot back to the previous track by holding r pressed during program
play.
• Repeat play and random play can be performed during program play.
N
1
2
3
ENTER/DISP
ENTER/DISP
M
PLAY MODE
5