Lincoln Electric IM10163 FLEX FEED 74 HT - Manual (Page 21)

A-14
INSTALLATION FLEX FEED™ 74 HT
LEFT HAND WIRE DRIVE
The Flex Feed 74 HT may be reassembled with the wire
drive on the left hand side. To convert to a left hand wire
drive:
Requires: G7644-1 Gun adapter cover, left
Tools required:
• Molex Mini-Fit JR Extraction Tool, part #11-03-0044
• Phillips Screw Driver
• 3/8” wrench
• 11/16” wrench
• 3/4” wrench
• 1/4” nut driver
• 5/16” nut driver
• 1/8” hex key
• 1/4 hex key
• pliers
1. Turn OFF power at the welding power source.
2. Using a Phillips screw driver, loosen the screw securing
the gun adapter cover. Remove the gun adapter cover.
FIGURE A.19
3. With a 3/4” wrench, remove the bolt holding the
electrode lead to the gun adapter.
FIGURE A.20
4. Use a 1/8” hex key to loosen the set screw securing
the gun adapter.
FIGURE A.21
5. Remove the sense lead with a Phillips screw driver.
FIGURE A.22
6. If a gas hose is attached to the gun adapter, use
pliers to remove the hose clamp and remove the gas
hose.
7. Loosen the socket head cap screw at the bottom of
the feed plate and slide the feed plate off of the gear
box.
FIGURE A.23
SCREW
GUN
ADAPTER
COVER
SET SCREW
GUN ADAPTER
SENSE
LEAD
SOCKET HEAD CAP SCREW
ELECTRODE
LEAD
BOLT