Lincoln Electric IM10109 CIRCULATOR - Manual (Page 25)

D-2 MAINTENANCE D-2
MAINTENANCE SCHEDULE
NOTE: * REQUIRES Lincoln Electric factory autho-
rized service technician.
AS NEEDED
• Replace filters (See filter replacement instructions).
• Inspect and test functionality of the filter media
cleaning system. *
• Program and verify system auto on/off timer (PLC). *
• Clean spiral ducting. *
MONTHLY
• Check particulate collection barrels and dispose of
particulate if necessary.
• Check and log filter pressure.
EVERY 6 MONTHS
• Ensure that the Cubic Feet per Minute (CFM) is
operating to the engineered specifications based on
the individual system *
STATIFLEX 6000 Filter Housings
• Check the integrity of the filter housing and tighten
all bolts and screws as needed.
• Clean housing with a non-aggressive detergent.
• Check the connections to the duct work, seal if nec-
essary.
• Check incoming air pressure.
• Inspect and clean (with a non-aggressive detergent)
the filter control box.
YEARLY
• Change membrane S23281-62. *
• Change O-Ring S23281-68. *
MOTOR/FAN HOUSING
(SOUND ABSORBING ENCLOSURE)
• Check the integrity of the fan housing (sound
absorbing box) and tighten all bolts and screws if
necessary.
• Verify unit is level and adjust if necessary.
• Clean housing (sound absorbing enclosure) with a
non-aggressive detergent.
• Check connection of silencer to fan housing and seal
if necessary.
• Check connection of ductwork to silencer and seal if
necessary.
• Check fan motor blades for encrusted particles and
clean if necessary.
• Inspect and clean control panel with a non-aggres-
sive detergent.
• Inspect flex connection (blue) inside fan housing
(sound absorbing enclosure).
• Check inlets and outlets for tears or wear.
CONTROL PANEL
• Check for functionality of control panel fan.
• Inspect and clean any buildup or dirt on fan blade
impellers in control panel.
• Inspect and replace control panel filters if necessary.
CIRCULATOR