Lincoln Electric IM10109 CIRCULATOR - Manual (Page 23)

B-7 OPERATION B-7
AUTOMATIC SYSTEM START-UP
1. Follow Set Weekly Timer procedure.
OVERTIME SYSTEM START-UP
1. Press Overtime button.
a. Pressing button will override system to run
an additional 10 hours.
PLC START-UP PROCESS
1. Press to show time and date.
2. Press ESC.
3. Select ʻStartʼ..: Press
or .
a. If “Stop” is the first item displayed, system
is already in START mode.
b. Press ESC.
4. Confirm “Start”: Press OK.
5. Press ESC.
SET WEEKLY TIMER
There are four week timers (Timer 1 thru 4) installed
in the program, each consisting of three screens.
To change the timer settings, proceed as follows. This
procedure can be executed via the PLC display on the
outside of the control panel.
1. Press to show time and date.
2. Press ESC.
3. Select ʻSet Paramʼ: Press
or .
4. Press OK.
5. Press or to change cursor position. Press
or to change value.
6. Press OK.
NOTE: Timer 1 - screen 4: make sure setting
Pulse = Off.
If desired, Timers 2 to 4 can be used to set
additional on/off moments of the fan, resulting
in a start up of the filter cleaning process.
7. Press several times until Timer 2 shows up. Set
additional time settings.
8. Press ESC (3) three times to return to the date and
time screen.
Press Start.
Press STOP in case of emergency. See
Troubleshooting Section in this manual.
CIRCULATOR
FIGURE B.4
S
F1 F2 F3 F4 ESC OK
LOGO! TD