Lincoln Electric IM10109 CIRCULATOR - Manual (Page 13)

2. Mount the adapter onto the connection ring. See
Figure A.7.
3. Do not slide the adapter all the way on to the con-
nection ring. Leave approximately ½” inch
exposed. See Figure A.7.
4. Secure the adapter to the connection ring using
four self tapping screws and duct tape if neces-
sary. See Figure A.7.
5. Mount the duct connector to the adapter. See
Figure A.7.
6. Position the fan cabinet into place. Check that the
filter outlet and the fan inlet are at the same height.
Adjust the feet if necessary. See Figure A.7.
7. Slide the duct connector inside the fan inlet hole.
See Figure A.7.
8. Secure all connections using self tapping screws.
Apply silicone sealant if necessary.
A-5 INSTALLATION
CIRCULATOR
A-5
2. Insert leg connectors half way into leg frames. See
Figure A.5.
3. Insert bolts and washers into lower holes and hand
tighten.
See Figure A.5.
4. Using a lift or hoist, position the assembled air inlet
module onto the leg assembly.
5. Insert bolts and washers into upper holes of the
leg connectors. Using a 13mm nutdriver, tighten
all nuts and bolts securely.
Connection Of Filter Base To Frame
1. Carefully move extraction fan cabinet from skid
and place onto thin leg assembly. See Figure A.6.
NOTE: Recessed bottom of fan cabinet should line up
to accept top rails of leg assembly. No fasten-
ers required.
Connection Of Filter Unit To Fan
1. The fan extraction cabinet (with leg assembly)
should be positioned so that the fan inlet hole
aligns with the filter outlet hole on the air inlet mod-
ule. See Figure A.7.
NOTE: The unit must be at the same height and level
to one another.
FIGURE A.6
EXTRACTION FAN
CABINET
LEG ASSEMBLY
FIGURE A.7
EXTRACTION FAN CABINET
AIR INLET MODULE
FAN INLET HOLE
FILTER OULET
HOLE
ADAPTER
CONNECTION RING
DUCT
CONNECTOR
• Lift only with equipment of ade-
quate lifting capacity.
• Be sure machine is stable when
lifting.
• Do not operate machine while
suspended or when lifting.
FALLING EQUIPMENT can cause injury.
------------------------------------------------------------
WARNING