IEI Integration AFL2-W15B-H61 - Manual (Page 64)

Page 46
AFL2-W15B-H61
Figure 3-29: RJ-45 Serial Port Connector
Step 4: Secure the connector. Secure the serial device connector to the external
interface by tightening the two retention screws on either side of the connector.
Step 0:
3.13.5 Type K Temperature Sensor Connection
The AFL2-W15B-H61 has a type K thermocouple connector on the bottom panel. The
type K connector is connected to a type K temperature sensor cable, which can be found
in the packing list. To connect a type K temperature sensor cable to the AFL2-W15B-H61,
please follow the steps below.
Step 1: Locate the type K connector on the bottom panel. See Figure 3-30.
Step 2: Align the connectors. Align the type K connector on the type K temperature
sensor cable with the type K connector on the AFL2-W15B-H61.
Step 3: Insert the temperature sensor cable type K connector. Once aligned, gently
insert the temperature sensor cable type K connector into the external interface.
Figure 3-30: Type K Temperature Sensor Installation