Figure 7-4: ddr so-dimm module installation – IEI Integration AFL2-W15B-H61 User Manual

Page 144

Page 126

AFL2-W15B-H61

Step 1:

Follow all anti-static procedures. See Section 7.2.

Step 2:

Turn off the power. See Section 7.3.

Step 3:

Remove the back cover. See Section 7.4.1 above.

Step 4:

Remove the internal aluminum back cover. See Section 7.4.2 above.

Step 5:

Locate the DDR3 SO-DIMM on the motherboard.

Step 6:

Remove the DDR3 memory module by pulling both the spring retainer clips

outward from the socket.

Step 7:

Grasp the DDR3 memory module by the edges and carefully pull it out of the

socket.

Step 8:

Install the new DDR3 memory module by pushing it into the socket at an angle

Step 9:

Gently pull the spring retainer clips of the SO-DIMM socket out and push the

rear of the DDR memory module down (Figure 7-4).

Step 10:

Release the spring retainer clips on the SO-DIMM socket. They clip into place

and secure the DDR memory module in the socket.

Figure 7-4: DDR SO-DIMM Module Installation

Step 11:

Replace the internal aluminum cover and secure it to the chassis using six (6)

retention screws.