IEI Integration AFL2-W15B-H61 - Manual (Page 140)

Page 122
AFL2-W15B-H61
7.1 System Maintenance Introduction
If the components of the AFL2-W15B-H61 fail they must be replaced. Components that
can be replaced include:
ƒ SO-DIMM module
ƒ WLAN module
Please contact the system reseller or vendor to purchase the replacement parts. Back
cover removal instructions for the AFL2-W15B-H61 are described below.
7.2 Anti-static Precautions
WARNING:
Failure to take ESD precautions during the maintenance of the
AFL2-W15B-H61 may result in permanent damage to the
AFL2-W15B-H61 and severe injury to the user.
Electrostatic discharge (ESD) can cause serious damage to electronic components,
including the AFL2-W15B-H61. Dry climates are especially susceptible to ESD. It is
therefore critical that whenever the AFL2-W15B-H61 is accessed internally, or any other
electrical component is handled, the following anti-static precautions are strictly adhered
to.
ƒ Wear an anti-static wristband: - Wearing a simple anti-static wristband can
help to prevent ESD from damaging the board.
ƒ Self-grounding: - Before handling the board touch any grounded conducting
material. During the time the board is handled, frequently touch any
conducting materials that are connected to the ground.
ƒ Use an anti-static pad: - When configuring the AFL2-W15B-H61, place it on
an antic-static pad. This reduces the possibility of ESD damaging the
AFL2-W15B-H61.
ƒ Only handle the edges of the PCB: - When handling the PCB, hold the PCB
by the edges.