IEI Integration AFL2-W15B-H61 - Manual (Page 52)

Page 34
AFL2-W15B-H61
3.12.2 Panel Mounting
To mount the AFL2-W15B-H61 flat bezel panel PC into a panel, please follow the steps
below.
Step 1: Select the position on the panel to mount the flat bezel panel PC.
Step 2: Cut out a section corresponding to the size shown below. The size must be
smaller then the outer edge.
Figure 3-17: Cutout Dimensions
Step 3: Slide the flat bezel panel PC through the hole until the frame is flush against the
panel.
Step 4: Align the panel mounting bracket screw holes with the VESA mounting holes on
the rear of the panel PC.
Step 5: Secure the two panel mounting brackets to the rear of the panel PC by inserting
the four retention screws into the VESA mounting holes (Figure 3-18
n
).
Step 6: Insert the panel mounting clamps into the holes of the panel mounting brackets
(Figure 3-18
o
). There are a total of 4 panel mounting clamps for
AFL2-W15B-H61.