IEI Integration AFL2-W15B-H61 - Manual (Page 54)

Page 36
AFL2-W15B-H61
NOTE:
When purchasing the cabinet/rack installation bracket, make sure it is
compatible with both the AFL2-W15B-H61 flat bezel panel PC and the
rack/cabinet into which the AFL2-W15B-H61 is installed.
Step 9: Slide the rear chassis of the AFL2-W15B-H61 flat bezel panel PC through the
rack/cabinet bracket until the aluminum frame is flush against the front of the
bracket (Figure 3-19).
Figure 3-19: The Rack/Cabinet Bracket
Step 1: Align the panel mounting bracket screw holes with the VESA mounting holes on
the rear of the panel PC.
Step 2: Secure the two rack mounting brackets to the rear of the panel PC by inserting
the four retention screws into the VESA mounting holes (Figure 3-20
n
).
Step 3: Insert the rack mounting clamps into the holes of the rack mounting brackets
(Figure 3-20
o
). There are a total of 4 rack mounting clamps for
AFL2-W15B-H61.
Step 4: Tighten the screws that pass through the rack mounting clamps until the plastic
caps at the front of all the screws are firmly secured to the panel.