2 rj-45 serial port connection, Figure 3-28: db-9 serial port connector – IEI Integration AFL2-W15B-H61 User Manual

Page 63

Page 45

AFL2-W15B-H61

Figure 3-28: DB-9 Serial Port Connector

Step 3:

Secure the connector. Secure the serial device connector to the external

interface by tightening the two retention screws on either side of the connector.

3.13.4.2 RJ-45 Serial Port Connection

Follow the steps below to connect a serial device to the RJ-45 serial port connector of the

AFL2-W15B-H61 panel PC.

Step 1:

Locate the RJ-45 serial port. The location of the RJ-45 serial port is shown in

Chapter 1.

Step 2:

Connect the RJ-45 to COM port cable to the panel PC. Insert the RJ-45

connector end of cable into the RJ-45 serial port. See Figure 3-29.

Step 3:

Connect the serial device. Connect a serial device to the DB-9 connector end

of the cable. See Figure 3-29.