IEI Integration S12A v1.12 - Manual (Page 27)

SAILORPC-12A Panel PC
Page 17
Step 4: Make sure the outer seal is seated properly, then replace the cover. S te p 0 :
3.4 Jumper Settings
NOTE:
A jumper is a metal bridge that is used
to close an electrical circuit. It consists
of two metal pins and a small metal clip
(often protected by a plastic cover) that
slides over the pins to connect them.
To CLOSE/SHORT a jumper means
connecting the pins of the jumper with
the plastic clip and to OPEN a jumper means removing the plastic clip
from a jumper.
3.4.1 Reset CMOS
Jumper Label: JP11
Jumper Type: 3-pin header
Jumper Settings: See Table 3-1
This jumper will reset the CMOS. Turn off the system. Set the jumper to "Reset CMOS",
turn on the power for a few seconds. Turn off the system. Set the jumper back to "Normal".
Pin Description
1-2 Normal
2-3 Reset CMOS
Table 3-1: Reset CMOS
3.4.2 AT/ATX Power
Jumper Label: JP10
Jumper Type:
2-pin header