3 compactflash® installation, Ompact, Lash – IEI Integration S12A v1.12 User Manual
Page 26: Nstallation, Figure 3–3: hdd installation, Figure 3–4: compactflash® install
SAILORPC-12A Panel PC
Page 16
Step 3:
Slide the SATA hard drive into the slot indicated below.
Figure 3–3: HDD Installation
Step 4:
Fasten the screws.
Step 5:
Make sure the outer seal is seated properly, then replace the cover.
S
te
p
0
:
3.3 CompactFlash® Installation
This section covers the installation of the CompactFlash® card.
Step 1:
Remove the back cover as shown in the hard drive installation above.
Step 2:
Install the CompactFlash® card in the slot indicated below.
Figure 3–4: CompactFlash® Install
Step 3:
Replace the cover and fasten the screws.
This manual is related to the following products: