IEI Integration WAFER-945GSE2 v2.00 - Manual (Page 67)

WAFER-945GSE2 3.5" Motherboard
Page 52
Figure 4-9: Dual RS-232 Cable Installation
Step 3: Secure the connectors. Both single RS-232 connectors have two retention
screws that must be secured to a chassis or bracket.
Step 4: Connect the serial device. Once the single RS-232 connectors are connected
to a chassis or bracket, a serial communications device can be connected to the
system.
4.6.3 Keyboard/Mouse Y-cable Connector
The WAFER-945GSE2 is shipped with a keyboard/mouse Y-cable connector. The
keyboard/mouse Y-cable connector connects to a keyboard/mouse connector on the
WAFER-945GSE2 and branches into two cables that are each connected to a PS/2
connector, one for a mouse and one for a keyboard. To connect the keyboard/mouse
Y-cable connector, please follow the steps below.
Step 1: Locate the connector. The location of the keyboard/mouse Y-cable connector
is shown in Chapter 3.
Step 2: Align the connectors. Correctly align pin 1 on the cable connector with pin 1 on
the WAFER-945GSE2 keyboard/mouse connector. See Figure 4-10.
Step 3: Insert the cable connectors . Once the cable connector is properly aligned with