IEI Integration WAFER-945GSE2 v2.00 - Manual (Page 60)

WAFER-945GSE2 3.5" Motherboard
Page 45
Setting Description
OFF Slave (Default)
Short 1-2 Master
Table 4-3: CF Card Setup Jumper Settings
Figure 4-3: CF Card Setup Jumper Location
4.4.3 Clear CMOS Jumper
Jumper Label: J_CMOS1
Jumper Type: 3-pin header
Jumper Settings: See Table 4-4
Jumper Location: See Figure 4-4
If the WAFER-945GSE2 fails to boot due to improper BIOS settings, the clear CMOS
jumper clears the CMOS data and resets the system BIOS information. To do this, use the
jumper cap to close pins 2 and 3 for a few seconds then reinstall the jumper clip back to
pins 1 and 2.
If the “CMOS Settings Wrong” message is displayed during the boot up process, the fault
may be corrected by pressing the F1 to enter the CMOS Setup menu. Do one of the
following:
Enter the correct CMOS setting
Load Optimal Defaults
Load Failsafe Defaults.
After having done one of the above, save the changes and exit the CMOS Setup menu.