IEI Integration PM-PV-N4551_D5251 - Manual (Page 65)

PM-PV-D4251/N4551/D5251 User Manual
Page 53
Figure 4-13: SATA Power Drive Connection
4.8.4 USB Cable (Dual Port without Bracket)
The PM-PV-D4251/N4551/D5251 is shipped with a dual port USB 2.0 cable. To connect
the USB cable connector, please follow the steps below.
Step 1: Locate the connectors. The locations of the USB connectors are shown in
Chapter 3.
WARNING:
If the USB pins are not properly aligned, the USB device can burn out.
Step 2: Align the connectors. The cable has two connectors. Correctly align pin 1on
each cable connector with pin 1 on the PM-PV-D4251/N4551/D5251 USB
connector.
Step 3: Insert the cable connectors. Once the cable connectors are properly aligned
with the USB connectors on the PM-PV-D4251/N4551/D5251, connect the cable
connectors to the on-board connectors. See Figure 4-14.