IEI Integration PM-PV-N4551_D5251 - Manual (Page 51)

PM-PV-D4251/N4551/D5251 User Manual
Page 39
WARNING:
A CPU should never be turned on without its heat sink being installed.
If the heat sink is removed and the system turned on, permanent
damage to the CPU, PM-PV-D4251/N4551/D5251 and other electronic
components attached to the system may be incurred. Running a CPU
without a heat sink may also result in injury to the user.
4.3 Unpacking
When the PM-PV-D4251/N4551/D5251 is unpacked, please do the following:
ƒ Follow the anti-static precautions outlined in Section 4.1.
ƒ Make sure the packing box is facing upwards so the
PM-PV-D4251/N4551/D5251 does not fall out of the box.
ƒ Make sure all the components in the unpacking list are present.
NOTE:
If some of the components listed in the unpacking list are missing,
please do not proceed with the installation. Contact the IEI reseller or
vendor you purchased the PM-PV-D4251/N4551/D5251 from or
contact an IEI sales representative directly. To contact an IEI sales
representative, please send an email to [email protected].
4.4 SO-DIMM Installation
To install an SO-DIMM, please follow the steps below and refer to Figure 4-1.