beautypg.com

3 compactflash® setup, 4 lvds voltage selection, Figure 4-5: compactflash® setup jumper location – IEI Integration PM-PV-N4551_D5251 User Manual

Page 56: Table 4-4: compactflash® setup jumper settings

background image

PM-PV-D4251/N4551/D5251 User Manual

Page 44

4.6.3 CompactFlash® Setup

Jumper Label:

SW_CF1

Jumper Type:

switch

Jumper Settings:

See Table 4-4

Jumper Location:

See Figure 4-5

The CompactFlash® slot is connected through an IDE connection. This switch sets the

CompactFlash® card as the master or slave IDE device.

Setting Description

Default position

(marked on board)

Slave

Other position

Master

Table 4-4: CompactFlash® Setup Jumper Settings

Figure 4-5: CompactFlash® Setup Jumper Location

4.6.4 LVDS Voltage Selection

WARNING:

Incorrect voltages can destroy the LCD panel. Make sure to select a

voltage that matches the voltage required by the LCD panel.

See also other documents in the category IEI Integration Hardware: