beautypg.com

6 jumper settings, Umper, Ettings – IEI Integration PM-PV-N4551_D5251 User Manual

Page 53: Figure 4-2: compactflash® card installation

background image

PM-PV-D4251/N4551/D5251 User Manual

Page 41

Figure 4-2: CompactFlash® Card Installation

4.6 Jumper Settings

NOTE:

A jumper is a metal bridge that is used to

close an electrical circuit. It consists of two

metal pins and a small metal clip (protected

by a plastic cover) that slides over the pins

to connect them. To CLOSE/SHORT a

jumper means connecting the pins of the

jumper with the plastic clip and to OPEN a

jumper means removing the plastic clip from a jumper.

Before the PM-PV-D4251/N4551/D5251 is installed in the system, the jumpers must be

set in accordance with the desired configuration. There are three jumpers on the

PM-PV-D4251/N4551/D5251. These three jumpers are listed in the table below.

See also other documents in the category IEI Integration Hardware: