8 internal peripheral device connections, 1 keyboard/mouse y-cable connector, Nternal – IEI Integration PM-PV-N4551_D5251 User Manual
Page 60: Eripheral, Evice, Onnections
PM-PV-D4251/N4551/D5251 User Manual
Page 48
NOTE:
IEI has a wide range of backplanes available. Please contact your
vendor, reseller or an IEI sales representative at [email protected] or
visit the IEI website () to find out more about
the available chassis.
4.8 Internal Peripheral Device Connections
This section describes the installation of various peripheral connectors available for the
PM-PV-D4251/N4551/D5251.
4.8.1 Keyboard/Mouse Y-cable Connector
The PM-PV-D4251/N4551/D5251 is shipped with a keyboard/mouse Y-cable connector.
The keyboard/mouse Y-cable connector connects to a keyboard/mouse connector on the
PM-PV-D4251/N4551/D5251 and branches into two cables that are each connected to a
PS/2 connector, one for a mouse and one for a keyboard. To connect the keyboard/mouse
Y-cable connector, please follow the steps below.
Step 1:
Locate the connector. The location of the keyboard/mouse Y-cable connector is
shown in Section 3.1.1.
Step 2:
Align the connectors. Correctly align pin 1 on the cable connector with pin 1 on
the PM-PV-D4251/N4551/D5251 keyboard/mouse connector. See Figure 4-9.
Step 3:
Insert the cable connectors
.
Once the cable connector is properly aligned with
the keyboard/mouse connector on the PM-PV-D4251/N4551/D5251, connect
the cable connector to the onboard connectors. See Figure 4-9.