Vga port installation, Mounting the pm-lx-800 motherboard, Airflow consideration – IEI Integration PM-LX-800 v1.0 User Manual
Page 75
Page 75
PM-LX-800 CPU Card
Step 3:
Step 1:
Step 2:
Step 3:
Connect the other end of the cable to standard USB connectors.
Step 0:
4.3.15 VGA Port Installation
The cable used to connect the motherboard to a VGA port is a 10-pin header to female
HD-D-sub 15 connector. To connect a VGA port to the motherboard, follow the
instructions below.
Find the VGA cable in the kit that came with the motherboard.
Connect the 10-pin connector end of the cable to the VGA1 box header on the
motherboard. A keyed pin on the connector prevents it from being connected
incorrectly.
Connect the other end of the cable to standard male HD-D-sub 15 VGA
connector.
Step 0:
4.3.16 Mounting the PM-LX-800 Motherboard
The PM-LX-800 motherboard has a standard PCI-104 connector on the front side.
Baseboards can be designed by the end user, customized by IEI, or purchased from IEI.
For more information visit the IEI webs
r contact an IEI sales
representative.
To install the module, follow the instructions below.
Step 1:
Step 2:
Align the PCI-104 connector with the corresponding connector on a compatible
module.
Gently push the motherboard down to ensure the connectors are properly
connected.
Step 0:
4.3.17 Airflow Consideration
Although the embedded board can operate without active cooling, it is still necessary to
install the board in a chassis with ventilation holes on the sides allowing airflow to travel