IEI Integration PM-LX-800 v1.0 - Manual (Page 62)

Page 62
IEI® Technology, Corp.
Figure 3-19 VGA Connector Location
3.3 Onboard Jumpers
NOTE:
A jumper is a metal bridge used to close
an electrical circuit. It consists of two or
three metal pins and a small metal clip
(often protected by a plastic cover) that
slides over the pins to connect them. To
CLOSE/SHORT a jumper means
connecting the pins of the jumper with
the plastic clip and to OPEN a jumper
means removing the plastic clip from a
jumper.
Figure 3-20: Jumper Locations
The PM-LX-800 CPU Board has one onboard jumper (Table 3-2).