IEI Integration PICOe-PV-D4251_N4551_D5251 v1.10 - Manual (Page 60)

PICOe-PV-D4251/N4551/D5251 User Manual
Page 46
The CF Card Setup jumper location is shown in Figure 4-5.
Figure 4-5: CF Card Voltage Select Jumper Location
4.5.4 Clear CMOS Jumper
Jumper Label: J_CMOS1
Jumper Type: 3-pin header
Jumper Settings: See
830H
Table 4-5
Jumper Location: See
831H
Figure 4-6
If the PICOe-PV-D4251/N4551/D5251 fails to boot due to improper BIOS settings, the
clear CMOS jumper clears the CMOS data and resets the system BIOS information. To do
this, use the jumper cap to close pins 2 and 3 for a few seconds then reinstall the jumper
clip back to pins 1 and 2.
If the “CMOS Settings Wrong” message is displayed during the boot up process, the fault
may be corrected by pressing the F1 to enter the CMOS Setup menu. Do one of the
following:
 Enter the correct CMOS setting
 Load Optimal Defaults
 Load Failsafe Defaults.
After having done one of the above, save the changes and exit the CMOS Setup menu.
The clear CMOS jumper settings are shown in
832H
Table 4-5.