IEI Integration PCISA-9652 v1.01 - Manual (Page 116)

PCISA-9652 Half-Size CPU Card
Page 96
Center Subwoofer, connect to speakers. To install the audio kit, please refer to the steps
below:
Step 1: Connect the audio kit cable. The audio kit is shipped with a cable that
connects the audio kit to the PCISA-9652. Connect the cable to the connector
on the back of the audio kit. Make sure the pins are properly aligned (i.e. pin 1
connects to pin 1).
Step 2: Locate the audio connector. The location of the 10-pin audio connector is
shown in Chapter 3.
Step 3: Align pin 1. Align pin 1 on the on-board connector with pin 1 on the audio kit
cable connector. Pin 1 on the audio kit cable connector is indicated with a white
dot. See Figure 5-17.
Figure 5-17: 7.1 Channel Audio Kit
Step 4: Mount the audio kit onto the chassis. Once the audio kit is connected to the
PCISA-9652, secure the audio kit bracket to the system chassis.
Step 5: Connect the audio devices. Connect one speaker to the line-in audio jack, one
speaker to the line-out audio jack and a microphone to the mic-in audio jack.