Figure 5-14: sata drive cable connection – IEI Integration PCISA-9652 v1.01 User Manual

Page 113

PCISA -9652 Half-Size CPU Card

Page 93

The PCISA-9652 is shipped with two SATA drive cables and one SATA drive power cable.

To connect the SATA drives to the connectors, please follow the steps below.

Step 1:

Locate the connectors. The locations of the SATA drive connectors are shown

in Chapter 3.

Step 2:

Insert the cable connector. Press the clip on the connector at the end of the

SATA cable and insert the cable connector into the onboard SATA drive

connector. See Figure 5-14.

Figure 5-14: SATA Drive Cable Connection

Step 3:

Connect the cable to the SATA disk. Connect the connector on the other end

of the cable to the connector at the back of the SATA drive. See Figure 5-15.

Step 4:

Connect the SATA power cable. Connect the SATA power connector to the

back of the SATA drive. See Figure 5-15.

Step 0: