ZOLL M Series CCT Defibrillator Rev A - Manual (Page 23)

Configuration Settings
19
Cell Phone Type
This setting controls the active cellular phone profile for PCMCIA modem cards. It has no
effect on landline functionality. Pressing the Change Value softkey selects different phone
makes.
Select the phone make corresponding to your target cellular phone. For additional information
on cellular phone compatibility contact The Supply Net, Inc. at www.thesupplynet.com or
(800) 826-0279.
EtCO
2
Options
Pressing Set/Review causes a submenu to display, which allows review of or changes to the
following capnography options:
• Default EtCO2 Units: Sets EtCO
2
units to mmHg, kPa, or %
• Displayed Zoom Level: Sets the default scale setting for the displayed capnographic
waveform. Does not affect the printed waveform or the
waveform data stored on the data card.
• Default EtCO2 Comp Setting: Sets the default compensation for CO
2
Enable Leads Off
When set to “Yes” and ECG leads do not have proper contact with the patient, or the cable is not
properly attached to the M Series CCT unit, the ECG LEADS OFF message displays and a
dashed line displays in place of the ECG waveform. Yes is the default setting.
Note:
When using 12 Lead or Pacer mode, the M Series CCT unit functions as if this
configuration were set to “Yes.”
When set to “No” and ECG leads do not have proper contact with the patient or the cable is not
properly attached to the M Series CCT unit, the POOR LEAD CONTACT message and the
ECG waveform display.
Caution: Use care when interpreting ECG waveforms when the POOR LEAD CONTACT
message displays, because the ECG waveform may include a significant amount of
artifact. Whenever possible, reattach the leads before interpreting the waveform.
Blood Pressure Units
Sets the NIBP and IBP unit of measurement to mmHg or kPa.
NIBP Auto Interval Default
Sets the default for the amount of time between automatic measurements.
Trigger NIBP Meas on BP Alarm
When set to “Yes,” the M Series CCT unit initiates a single additional blood pressure
measurement when any of the NIBP alarms trigger.
Trigger NIBP Meas on HR Alarm
When set to “Yes,” the M Series CCT unit initiates a single blood pressure measurement when
heart rate/pulse rate alarm triggers.
NIBP First Inflate Pressure Default
Sets the default NIBP cuff inflation pressure (the pressure up to which the NIBP cuff inflates at
the beginning of each measurement).