Warner Electric 5370-101-042 Conduit Box Kit - Manual (Page 2)

2 Warner Electric • 800-825-9050 P- 1408 • 819-0344
Make sure all power is turned
off to this equipment when installing. Failure
to follow these instructions may result in
product damage, equipment damage, and
serious or fatal injury to personnel.
Introduction
This Warner Electric conduit box is designed to
provide a proper enclosure for wiring terminations.
It conforms to the requirements of Underwriters
Laboratories under UL508, Industrial Control
Equipment.
Parts list for kit 5370-101-042
Item Quantity Part Name
1 1 Conduit Box
2 1 Conduit Box Fitting
3 1 Cover Plate
4 6 Pan Head Tapping Screw
5 1 Hex. Washer Head Screw
6 1 Ring Terminal
7 2 Protective Plug
8 1 Cover (Plastic)
9 2 Gasket
10 1 Tooth Washer
Note: All screws are self tapping.
Assembly to Electro Module
1. Feed clutch/brake lead wires through tooth
washer (10) and bottom hole in conduit box (1)
and conduit box fitting (2). (See Figure 1)
Figure 1
2. Insert conduit box fitting (2) through bottom
hole of conduit box and thread into tapped hole
of module housing. Tighten securely to hold
box in place. (See Figure 2)
Note: Hold wires to prevent twisting.
Figure 2
3. Assemble 1/2" flexible conduit fitting into
desired end of conduit box. Avoid using excess
force which could damage the mounting. Install
protective plug (fitting only) (7) into conduit box
hole which is not used. (See Figure 3)