Warner Electric CBC-450 - Manual (Page 8)

output, Terminals 5 and 6 on Terminal
Block TB-2. Tighten terminals securely.
2. Connect Clutch 2 to the Channel 2 output,
Terminals 7 and 8 on Terminal Block TB-2.
Tighten terminals securely.
3. This completes the wiring of a dual clutch
arrangement. Proceed to the switching
input section for connection of switching
input circuits.
NOTe: In Simultaneous Mode (Dual) both
output channels are off at initial control power
up. When switched, both channels will be on
simultaneously.
c. Dual Brake Combination
1. Connect Brake 1 to the Channel 1 output,
Terminals 5 and 6 on Terminal Block TB-2.
Tighten terminals securely.
2. Connect Brake 2 to the Channel 2 output,
Terminals 7 and 8 on Terminal Block TB-2.
Tighten terminals securely.
3. This completes the wiring of a dual brake
arrangement. Proceed to the switching
input section for connection of switching
input circuits.
NOTe: In Simultaneous Mode (Dual) both
output channels are off at initial control power
up. When switched, both channels will be on
simultaneously.
Figure 7
5. Connections for Simultaneous Mode (Dual)
Operation
a. Clutch/Brake Combination
NOTe: Normally Clutch/Brake
Combinations are run in alternate mode
(single); however on some shaker or
vibratory conveyor applications both
clutch/brake may be operated
simultaneously. If in doubt about your
application, contact your local Warner
Electric representative.
1. Connect clutch to Channel 2 output,
Terminals 7 and 8 on Terminal Block
TB-2. Tighten terminals securely.
2. Connect brake to Channel 1 output,
Terminals 5 and 6 on Terminal Block
TB-2. Tighten terminals securely.
3. This completes the wiring for the
clutch/brake wiring. Proceed to
the switching input section for
connection of switching input circuits.
NOTe: In Simultaneous Mode (Dual) both
output channels are off at initial control
power up. When switched, both channels
will be on simultaneously.
b. Dual Clutch Combination
1. Connect Clutch 1 to the Channel 1
1
2
3
4
5
6
7
1
2
3
4
5
6
7
8
8
CH 2 CH 1
CBC-400-xx
Warner Electric
SGL Dual
Channel 2
Channel 1
AC Input
CBC-400 AC Power and Clutch-Brake Connections
+
+
-
-
TB-1 TB-2
See switching input wiring section for detailed
wiring/switch connections on TB-1
8 Warner Electric • 800-825-9050 P-239-23 • 819-0500