Warner Electric MCS-103-1 - Manual

Installation and Operation Manual
P-239-18
819-0478
MCS-103-1 Power Supply
with Single Torque Control
• Easy to install
• Compact unit mounts anywhere
• Convenient terminal strip behind an
easy-to-remove cover
• Internal arc suppression
• Operates with any Warner Electric 90V
Clutches or Brakes
The MCS-103-1 is an enclosed power supply
complete with a cover and mounting provisions.
A brake and clutch may be operated separately
with this power supply-or, two brakes or two
clutches, one unit on at a time, or clutch and ER
brake with both units on at a time. The external
wiring is connected to the terminal strip located
behind the cover.
Specifications
* Contact ratings given will operate all Warner Electric brake and clutch units. However, switches with ratings less than those
given may be used with fractional horsepower units provided the rating is equal to or greater than the coil current.
AC INPUT DC OUTPUT DIMENSIONS
(Approx.)
MOUNTING EXTERNAL SWITCHES
(Furnished by user)
120 VAC
50-60 HZ 1.25 amps
90 VDC for one unit
and adjustable from
0-90 VDC full wave
for second unit. 4-1/2" high
6-3/4" wide
2-3/4" deep Mounting centers 5-
1/2" wide, 3" high.
Knockouts for 1/2"
conduit. Double pole, double throw
maintained contact. Minimum
contact rating:10 amp, 28 volt
DC resistive or 10 amp, 120
volt AC inductive.*
Part Number:
6010-448-002
0.68
3.00 4.37
0.56 5.50
ÿ0.18 (4 PLCS)
(14.2)
(76.2) (111)
(17.3)
(4.6)
(139.7)
Dimensional
2.75
4
ÿ0.87 BOTH SIDES
6.62
0.12
я
(22)
(168.2)
(3.05)
(70)
(
1.00
(25.4)
1.06
(26.9)