Warner Electric CBC-450 - Manual (Page 10)

5. Connections for Simultaneous Mode (Dual)
Operation
a. Clutch/Brake Combination
NOTe: Normally, clutch/brake combinations
are run in alternate mode (single) operation;
however, on some shaker or vibratory
conveyor applications, both clutch and
brake may be operated simultaneously. If in
doubt about your application, contact your
local Warner Electric representative.
1. Connect the clutch to Channel 2
output Terminals 7 and 8 on Terminal
Block TB-2. Tighten terminal securely.
2. Connect the brake to Channel 1
output Terminals 5 and 6 Terminal
Block TB-2. Tighten terminals
securely.
3. This completes the wiring of the
clutch/brake wiring. Proceed to the
switching input section for connection
of the switching input circuits.
NOTe: In Simultaneous Mode (Dual), both
output channels are off at initial power up.
When switched, both outputs will be on
simultaneously.
b. Dual Clutch Combination
1. Connect clutch 1 to the Channel 1
output Terminals 5 and 6 of Terminal
Block TB-2. Tighten terminals securely.
2. Connect clutch 2 to the Channel 2 output
Terminals 7 and 8 of Terminal Block TB-2.
Tighten terminals securely.
3. This completes the wiring for a dual clutch
arrangement. Proceed to the switching
section for connections of switching input
circuits.
NOTe: In Simultaneous Mode (Dual), both output
channels are off at initial power up. When
switched, both outputs will be on simultaneously.
c. Dual Brake Combination
1. Connect brake 1 to the Channel 1 output
Terminals 5 and 6 of Terminal Block TB-2.
Tighten terminals securely.
2. Connect brake 2 to the Channel 2 output
Terminals 7 and 8 of Terminal Block TB-2.
Tighten terminals securely.
3. This completes the wiring of a dual brake
arrangement. Proceed to the switching
input section for connection of switching
input circuits.
NOTe: In Simultaneous Mode (Dual), both
output channels are off at initial power up.
When switched, both channels will be on
simultaneously.
1
1
1
2
2
2
3
3
3
4
4
4
5
5
5
6
6
6
7
7
8
8
AC Input wiring
terminal block
TB-3
CH 2 CH 1
CBC-450
Warner Electric
Channel 2
Channel 1
+
+
-
-
TB-1 TB-2 TB-3
CBC-450 AC Power and Clutch-Brake Connections
SGL Dual
See switching input wiring section for detailed
wiring/switch connections on TB-1
Figure 8
10 Warner Electric • 800-825-9050 P-239-23 • 819-0500