Vanguard CT-8000 User Manual

Page 30

CT-8000 USER’S MANUAL

REV 2

3.2.4. Setting the Units of Measure

The CT-8000 supports and displays both English and Metric calculations. You can switch
between the English and Metric systems using the steps below:

a. Start from the “START-UP” menu:

Press the

[3]

key (SETUP).

b. The following screen will be displayed:

Press the

[2]

key (MEASUREMENT UNITS).

c. The following screen will be displayed:

Press the

[1]

key (ENGLISH) or the

[2]

key (METRIC) to select the corresponding

measurement system. The measurement system will be set and you will be returned to
the “START-UP” menu.

NOTE

If the measurement system is changed, any relevant values in the working
memory will be automatically converted to the new system. Also, if retrieving
a test record from the Flash EEPROM, all data will be converted to the new
measurement system. There is no need to re-run a test.

SELECT UNITS:
1. ENGLISH

2. METRIC

3. ROT ENC 4.RES ENC

1. ANALYSIS POINTS

2. MEASUREMENT UNITS

3. SAVE / RESTORE

4. NEXT PAGE

1. RUN TEST 03/10/10

2. GET RSLT 09:04:05

3. SETUP

4. DIAGNOSTICS