Teledyne LeCroy Verification Script Engine (VSE) Manual - Manual (Page 62)

Teledyne LeCroy Verification Script Engine Reference Manual
Page 62 of 115
10.2 SetTimer()
Starts a timing calculation from the event at which this function was called.
Format:
SendTimer(timer_id = 0)
Parameters:
timer_id Unique timer identifier.
Example:
SetTimer(); # Start timing for timer with id = 0.
SetTimer(23); # Start timing for timer with id = 23.
Remark:
If this function is called a second time for the same timer ID, it resets the timer and starts timing the calculation
again from the point where it was called.