Teledyne LeCroy ZD1500 - Manual (Page 8)

ZD500, ZD1000, ZD1500
2 921921-00 Rev A
Operating Environment
The accessory is intended for indoor use and should be operated in a clean, dry
environment. Before using this product, ensure that its operating environment is
maintained within these parameters:
Temperature: 5° to 40° C.
Humidity: Maximum relative humidity 90 % for temperatures up to 31° C
decreasing linearly to 50 % relative humidity at 40° C.
Altitude: Up to 10,000 ft (3,048 m).
Introduction
The ZD Series of Differential Probes (ZD500, ZD1000 and ZD1500) are high
bandwidth active differential probes. The probes feature low noise, very high
input impedance and high common mode rejection, and are ideally suited for
signal integrity measurements in high-speed digital systems. With low input
capacitance and high input resistance, circuit loading is minimized.
The ZD Series probes can be used with Teledyne LeCroy’s WaveSurfer,
WaveRunner, WavePro, and WaveMaster series platforms with firmware version
6.4.1.x or later.
With the ProBus interface, the ZD Series probes become an integral part of the
oscilloscope. The probe can be controlled from the oscilloscope’s graphical user
interface. The oscilloscope provides power to the probe, so there is no need for
a separate power supply or batteries.
Key Benefits

High frequency performance

Low input capacitance

Wide dynamic range

ProBus interface

A wide variety of tips, leads, and grabbers for probing