Teledyne LeCroy ZD1500 - Manual (Page 29)

Instruction Manual
921921-00 Rev A 23
Safety Compliance
EC D ECLARATION OF C ONFORMITY
–
L OW V OLTAGE
The probe meets intent of EC Directive 2006/95/EC for Product Safety.
Compliance was demonstrated to the following specifications as listed in the
Official Journal of the European Communities:
EN 61010-1:2010 Safety requirements for electrical equipment for
measurement, control, and laboratory use – Part 1: General requirements
EN 61010-2:030:2010 Safety requirements for electrical equipment for
measurement, control, and laboratory use – Part 2-030: Particular requirements
for testing and measuring circuits
EN 61010-031/A1:2008 Safety requirements for electrical equipment for
measurement, control, and laboratory use – Part 031: Safety requirements for
hand-held probe assemblies for electrical measurement and test.
Environmental Compliance
E
ND
-O
F
-L
IFE
H
ANDLING
The probe is marked with this symbol to indicate that it complies
with the applicable European Union requirements to Directives
2002/96/EC and 2006/66/EC on Waste Electrical and Electronic
Equipment (WEEE) and Batteries.
The probe is subject to disposal and recycling regulations that vary
by country and region. Many countries prohibit the disposal of
waste electronic equipment in standard waste receptacles. For more
information about proper disposal and recycling of your Teledyne LeCroy
product, please visit teledynelecroy.com/recycle.
R ESTRICTION OF H AZARDOUS S UBSTANCES (R O HS)
This product has been classified as Industrial Monitoring and Control Equipment,
and is outside the scope of the 2011/65/EU RoHS Directive (Exempt until July
2017, per Article 4).
ISO Certification
Manufactured under an ISO 9000 Registered Quality Management System. Visit
teledynelecroy.com to view the certificate.