Teledyne LeCroy WaveExpert 9000_NRO9000_SDA100G Getting Started Manual - Manual (Page 8)

6 ISSUED: September 2005 WE-GS-E Rev A
Safety Requirements
This section contains information and warnings that must be observed to keep the scope
operating in a correct and safe condition. You are required to follow generally accepted safety
procedures in addition to the safety precautions specified in this section.
Safety Symbols
Where the following symbols appear on the scope’s front or rear panels, or in this manual, they
alert you to important safety considerations.
This symbol is used where caution is required. Refer to the accompanying
information or documents in order to protect against personal injury or damage
to the instrument.
This symbol warns of a potential risk of shock hazard.
This symbol is used to denote the measurement ground connection.
This symbol is used to denote a safety ground connection.
This symbol is used to denote a grounded frame or chassis terminal.
This symbol shows that the switch is a Standby (power) switch. When it is
pressed, the scope’s state toggles between operating and Standby mode. This
switch is not a disconnect device. The instrument can only be placed in a
complete Power Off state by unplugging the power cord from the AC supply.
This symbol is used to denote "Alternating Current."
The ESD symbol indicates a potential hazard. It calls attention to the
susceptibility of the equipment to electrostatic discharge (ESD) induced
damage if anti-static measures are not taken.