Steelcraft Automotive 114000 RUNNING BOARD - Manual

VIEWPOINT RUNNING BOARDS
2013 FORD ESCAPE
Page 1 of 7 9/12/12 (DP)
PARTS LIST:
1 Driver/Left Running Board 2 12mm Plastic Retainers
1 Passenger/Right Running Board 8 10mm Plastic Retainers
1 Driver/Left Front Mounting Bracket 2 12mm x 32mm x 3mm Flat Washers
1 Passenger/Right Front Mounting Bracket 2 12mm Lock Washers
1 Driver/Left Center Mounting Bracket 2 12mm Hex Nuts
1 Passenger/Right Center Mounting
Bracket 8 10mm x 27mm x 3mm Flat Washers
1 Driver/Left Rear Mounting Bracket 8 10mm Lock Washers
1 Passenger/Right Rear Mounting Bracket 8 10mm Hex Nuts
2 12mm x 35mm Special Bolt Plate (rear) 12 6mm T-Bolts
5 10mm x 30mm Button Head Bolt Plates 12 6mm x 22mm x 2mm Flat Washers
2 10mm x 30mm T-bolts (Both front outer) 12 6mm Lock Washers
1 10mm x 35mm T-bolt (Driver front inner) 12 6mm Hex Nuts
PROCEDURE:
1. REMOVE CONTENTS FROM BOX. VERIFY ALL PARTS ARE PRESENT. READ INSTRUCTIONS
CAREFULLY BEFORE STARTING INSTALLATION. CUTTING IS REQUIRED. ASSISTANCE IS
RECOMMENDED.
2. Start installation under the driver side of the vehicle. NOTE: To help determine the correct mounting
holes to use, hold the front Bracket up in position against the floor panel and line up the Bracket with
the correct holes, (Fig 1).
a. Driver side front Bracket installation:
Select (1) 10mm x 30mm Small T-Bolt and (1) 10mm Plastic Retainer, (Fig. 2A). Partially thread
the Retainer onto the T-Bolt. Insert the T-Bolt into the inner factory oval hole. Rotate the T-Bolt 90-
Driver/Left Rear
Mounting Bracket
Driver/Left Front
Mounting Bracket
Driver/Left
Center Bracket
Passenger/Right
Rear Mounting
Bracket
Passenger/Right
Center Bracket
Passenger/Right Front
Mounting Bracket
(2) 12mm x 35mm Bolt Plate
(Rear Brackets)
(5) 10mm x 30mm Bolt Plates
(2) 10mm x 35mm Small T-Bolt
(Driver Front Bracket Only)
(2) 10mm x 30mm Large T-Bolt
(Outer Front Brackets)
Driver/Left
Running Board
Passenger/Right
Running Board
Front